Xcem
Is pleased to present a dedicated microglass ionomer product for restoration of
children’s teeth.Apart from chemical adhesion and biocompatibility, the product
has a risk snap set and high fluoride release.Pricare is also recommended as a
pedodontic product where dental caries could not be removed affectively and yet
some arrest of carious process is desired.
INDICATIONS:
Permanent
restoration of deciduous teeth. Semi permanent restoration of teeth in cases of
rampant caries and where all dental could not be removed due to equipment and personal
limitations. Also useful for cementation of crowns and bridges and ortho bands.
For immediate restoration of traumatized teeth.
PRESENTATION:
20gm powder
9ml liquid
MIXING:
2DROPS LIQUID
3SCOOPS POWDER
MIXING TIME:
30SEC
WORKING TIME:
2MIN
SET TIME: 3.5MIN
FROM START OF MIX.
Invert powder bottle a few times to fluff up powder.
Level fill powder scoop without compressing powder. Always replace lid on
bottle after use .Liquid bottle should be inverted and squeezed to give
required drops of liquid on to mixing pads. Always replace lid immediately as
liquid may dry if let on bench without lid this can cause blockage of liquid
nipple. Initially add first heap of powder and mix to homogenous paste by using
metal spatula. Add rest of powder incrementally until required consistency. The
mixed material should have a glossy surface and is ready for use immediately.
HOW TO USE:
CAVITY
PREPARATION:
Minimal cavity prep is required. Enamel should be
preserved even if it undercut. If the cavity is very deep and there is almost
risk of pulp exposure, a calcium hydroxide liner such as PULPCAL is
recommended.
Following cavity preparation: Isolate tooth and dry
the cavity .Fill cavity with mixed pricare.taking care thoroughly until cavity
is overfilled. Pack as necessary and contour before the Pricare begins to form
a rubbery set stage .Trim away excess and cover with varnish immediately
.Pricare will set rapidly. Further adjustments to the restoration can be
carried out after 4min of mixing. Use fine grit stone to relive occlusal
surface and cover with varnish. For Class III and Class II, use of celluloid
Type strip matrix is recommended for excellent adaptation and surface finish.
Pricare
is also useful as fissure sealant where minimal fissure clearance have been
carried by inverted cone bur.
Where
it is not possible remove all dental decay. Use of glass ionomer may be
advantageous as a semi permanent restoration.
CAUTION:
Liquid
is adhesive and contains polyacrylic acid. Spatula and instruments should be
wiped clean before setting. Spillages should be cleaned immediately. In case
skin contact, wash with plenty of water and use eye washes as necessary.
Medical advice may be sought.
POWDER:
Very
fine powder may give rise to dust; however, small it is recommended that lid
shelled be replaced immediately after use.
STORAGE:
Store at normal room temperature in sealed from.