Xcem Ltd. is please to present a high compressive strength micro glass, which is further reinforced with silver alloy, a very strong core build product.
Apart from chemical adhesion and biocompatibility, the product has a brisk snap set and high fluoride release. Hycore Silver is also recommended as pedodontic restorative, also useful for general use.
INDICATION:
Permanent core build restorative.
Restorative for children’s teeth.
Semi-permanent restoration of teeth in cases of rampant caries and where all dental caries could not be removed due to equipment and personal limitations.
PRESENTATION:
30gm Powder
15ml Liquid
Mixing Pad
Measuring Scoop
Instruction Sheet
MIXING TIME: 30 Seconds
WORKING TIMES: 2 Minutes
SET TIME: 3.5 Minutes from start if mix at 23°C and 50% relative humidity.
HOW TO USE: Invert powder bottle a few times to fluff up powder. Level fill scoop without compressing powder. Always replace lid on bottle after use. Liquid bottle should be inverted and squeezed to give required drops of liquid onto mixing pad.
Always replace lid immediately as liquid may get dry without lid and this can cause blockage of the liquid tip.
Initially add first heap of powder and mix to homogenous paste by using metal spatula. Add rest of powder incrementally until required consistency. The mixed material should have a glossy surface and is ready for use immediately.
CAVITY PREPARATION: Minimal cavity preparation should be preserved even if it is undercut. If the cavity is very deep and there is risk of pulp exposure, a calcium hydroxide liner such as Carecal is recommended.
Following cavity prep, isolate tooth and dry the cavity. Fill cavity with mixed Hycore Silver, which can be condensed into a cavity plugger, taking care thoroughly until cavity is overfilled then pack as necessary and contour before the Hycore Silver begins to go to a rubbery set stage. Trim away excess and cover with varnish immediately. Hycore Silver will set rapidly; further adjustments to the restoration can be carries out after four minutes of mixing. Use of celluloid type strip matrix is recommended for excellent adaptation and surface finish. Hycore makes a strong core for restorations and crowns. The tooth can be prepared for crown as soon as Hycore sets.
To obtain greater adhesion, paint all aspects of cavity with conditioner bond prior to filling.
Where it is not possible to remove all dental decay use of glass ionomer may be advantageous as a semi-permanent restoration.
CAUTION:
Liquid is adhesive and contains polyacrylic acid.
Spatula and instruments should be wiped clean before setting.
Spillages should be cleaned immediately. In case of contact with skin/eyes, wash immediately with plenty of water. Seek medical advice if necessary.
Powder is very fine, it may give rise to dust, however small one is recommended that lid should be replaced immediately after use.
STORAGE: Storage at normal room temperature in a sealed form